of their action would be the lasting sound
of the falling dices which duration would be equal to the sum of
series of drops of every dice (extension of duration of the result of
action). If the domino dices are placed in a parallel row the result
of their action would be the short, but loud sound equal to the total
sound volume resulting from the drop of each separate dice (capacity
extension). The performance cycle of an ideal simple and composite
SFU is formed by micro cycles: perception and selection of external
influence by the “X” receptor and decision-making;
influence on the executive elements (SFU); response/operation of
executive elements (SFU); function termination. The “X”
receptor starts to operate following the onset of external influence
(the 1st micro cycle). Subsequently some time would be spent for the
decision-making, since this decision itself is the result of action
of certain SFU comprising the control block (the 2nd micro cycle).
Thereafter all SFU would be activated (joined in) (the 3rd micro
cycle). The operating time of the SFU response/operation depends on
the speed of utilization of energy spent for the SFU performance, for
example, the speed of reduction of sarcomere in a muscular cell which
is determined by speed of biochemical reactions in the muscular cell.
After that all SFU terminate their function (the 4th micro cycle). At
that, the SFU spends its entire energy it had and could use to
perform this action. As far as the sequence of actions and result of
action would always be the same, the measure of energy would always
be the same as well (energy quantum). In order for the SFU to be able
to perform a new action it needs to be “recharged”. It
may also take some time (the time of charging). The way it happens is
discussed in the section devoted to passive and active systems (see
below). Any SFU’s performance cycle consists of these micro
cycles. Therefore, its operating cycle time would always be the same
and equal to the sum of these micro cycles. Once SFU started its
actions, it would not stop until it has accomplished its full cycle.
This is the reason of uncontrollability of any SFU in the course of
their performance (absolute adiaphoria), whereby the external
influence may quickly finish and resume, but it would not stop and
react to the new external influence until the SFU has finished its
performance. In real composite SFU these micro cycles may be
supplemented by micro cycles caused by imperfection of real objects,
for example, non-synchronism of the executive elements’
operation due to their dissimilarity. Hence, it follows that even the
elementary systems represented by SFU do not react/operate
immediately and they need some time to produce the result of action.
It is this fact that explains the inertness/lag effect/ of systems
which can be measured by using the time constant parameter. But
generally speaking it is not inertness/lag effect/, but rater a
transitory (intermittent) inertness of an object (adiaphoria), its
inability to respond to the external influence at certain phases of
its performance. True inertness is explained by independence of the
result of action of the system which produced this result (see
below). Time constant is the time between the onset of external
influence and readiness for a new external influence after the
achievement of the result of action. The analogues of composite SFU
are all objects which operate similarly to avalanche. The “domino
principle” works in such cases. One impact brings about the
downfall of the whole. However, the number of downfalls would be
equal to the number of SFU. Pushing one domino dice will cause its
drop resulting just in one click. Pushing a row of domino dices will
result in as many clicks as is the number of dices in the row.
Biological analogues of composite SFU are, for example, functional
ventilation units (FVU), each of which consisting of large group
(several hundred) of alveoli which are simultaneously joining in
process of ventilation or escape from it. Liver acynuses, vascular
segments of mesentery, pulmonary vascular functional units, etc., are
the analogues of composite SFU. Thus, simple SFU is the object which
can react to certain external influence, while the result of its
performance would always be maximal because the control block would
not control it, i.e. it works under the “all-or-none”
law. The type of its reaction is caused by the type of SFU. There are
two kinds of simple SFU: uncontrollable and controllable. Both react
to the specific external influence. But additional external
permission signal at the command entry point is required for the
operation of controllable SFU, whereas the uncontrollable SFU have no
command entry point. Therefore, the uncontrollable SFU does not
depend on any external guiding signals. The control block of
controllable and uncontrollable SFU consists of the
analyzer-informant and has only DPC (the “Х”
informant and afferent channels). The composite Systemic Functional
Unit is a kind of an object similar to simple SFU, but the result of
its action is stronger. It works under the “all-or-none”
law, too, and its reaction is stipulated by type and number of its
SFU. It can really be that the constituent parts of composite SFU may
be controllable and uncontrollable, and the difference between them
may only be stipulated by the presence of command entry point in the
general control block through which the permission for the
performance of action is communicated. The control block of a system
is elementary, too, and has only DPC and analyzer-informant. Hence,
any SFU function under the “all-or-none” law. SFU is
arranged in such a way that it either does nothing, or gives out a
maximal result of action. Its elementary result of action is either
delivered or not delivered. There might be SFU which delivers the
result of action, for example, twice as large as the result of action
of another SFU. But it will always be twice as large. Each result of
action of a simple SFU is quantum of action (indivisible portion), at
that being maximal for the given SFU. It is indivisible because SFU
cannot deliver part (for instance, half) of the result of action. And
as far as it is “the indivisible portion” there can not
be a gradation. For instance, SFU may be opened or closed, generate
or not generate electric current, secrete or not secrete something,
etc. But it cannot regulate the quantity of the result of action as
its result always is either not delivered or is maximal. Such
operating mode is very rough, inaccurate and unfavorable both for the
SFU per se and its goal/objective. Let’s imagine that instead
of a steering wheel in our car there will be a device which will
right away maximally swerve to the right when we turn a steering
wheel to the right or will maximally swerve to the left if we turn it
to the left. Instead of smooth and accurate trimming to follow the
designate course of movement the car will be harshly rushing about
from right to left and other way round. The goal will not be achieved
and the car will be destroyed. Basically the composite Systemic
Functional Unit could have delivered graded result of action since it
has several SFU which it could actuate in a variable sequence. But
such system cannot do so because it “does not see” the
result of action and cannot compare it with what should be done/what
it should be.
Quantity of the
result of action. To achieve the preset goal the designation of the
quality of the result of action only is not sufficient. The goal sets
not only “what action the object should deliver” (quality
of the result of action), but also “how much of this action”
the given object should deliver (quantity of the result of action).
And the system should seek to perform exactly as much of specific
action as it is necessary, neither more nor less than that. The
quality of action is determined by SFU type. The quantity
is determined by the
quantity of SFU. There are three quantitative characteristics of the
result of action: maximum, minimum and optimum quantity of action. In
the real world gradation of the results of action is required from
the real systems. Therefore, the system performance should deliver
neither maximum nor minimum, but optimum result. Optimum means
performance based on the principle “it is necessary and
sufficient”. It is necessary that the result of action should
be such-and-such, but not another in terms of quality and adequate in
terms of quantity, neither more nor less. Hence, the SFU cannot be
the full-fledged systems. The systems are needed in which
controllable/adjustable grading of the result of action would be
possible. For example, it is required that the pressure of 100 mm Hg
is maintained in the tissue capillaries. This phrase encompasses
presetting of everything what is included in the concept “necessary
and sufficient” at once. It is necessary... pressure, and it is
enough... 10 mm Hg. It is possible to collate the SFU providing
pressure, but not of 10 mm Hg, but, for instance, 100 mm Hg. It is
too much. It is probably possible to collate the
SFU which can provide
pressure of 10 mm Hg and at the moment it might be sufficient. But if
the situation has suddenly changed and the requirement is now 100 mm
Hg rather than 10 mm Hg, what should be done then? Should one run
about and search for SFU which may provide the 100 mm Hg? And what if
it’s impossible to make such system which would be able to
provide any pressure in a range, for example, from 0 to 100 mm Hg,
depending on a situation? In order to provide the quantity of the
result of action which is necessary at the moment, the grading of the
results of action of systems is required. It could have been achieved
by building the systems from a set of homotypic SFU of a type of
composite SFU flow diagram. It has what is needed for the graduation
of the result of action as it contains numerous SFU. If it could be
possible to do it so that it enables actuating from one to all of
SFU, depending on the need, the result of action would have as much
gradation as many SFU is present in the system. The higher the
required degree of accuracy, the more of minor gradations of the
result of action should be available. Therefore, instead of one SFU
with its extremely large scale result of action it is necessary to
use such amount of SFU with minor result of action which sum is equal
to the required maximum, while the accuracy of implementation of the
goal is equal to the result of action of one SFU. However, composite
SFU has no possibility to control the result of action as it has no
the unit able of doing it. To deliver the result of action precisely
equal to the preset one, it (the result of action) needs to be
continually measured and measuring data compared with the task (with
command, with “database”). The “database” is
a list of those due values of result of action which the system
should deliver depending on the magnitude of external influence and
algorithm of the control block operation. The goal of the system is
that each value of the measured external influence should be
corresponded by strictly determined value of the result
of action (due value). To
this effect it is necessary “to see” (to measure) the
result of action of the system to compare it to the appropriate/due
result. And for this purpose the control block should have a “Y”
receptor which can measure the result of action and there should be a
communication/transmission link (reciprocal paths) through which the
information from a “Y” receptor would pass to the
analyzer-informant, where the result of this measurement should be
compared with what should be/occur (with “database”). The
control block of the system should compare external influence with
the due value, whereas the due value should be compared with own
result of action to see its conformity or discrepancy with the due
value. Composite SFU still can compare external influence with eigen
result of action, because it has DPC, whereas it can not any longer
compare due value with the result of eigen action just because it
does not have anything able of doing it (there are no appropriate
elements).
Simple control block
(negative feedback - NF). In order for the control block of the
system to “see” (to feel and measure) the result of
action of the system, it should have a corresponding “Y”
receptor at the outlet/exit point/ of system and the communication
link between it and a “Y” receptor (reciprocal path). The
logic of operation of such control consists in that if the scale of
the result of action is lager than that of the preset result it is
necessary to reduce it, having activated smaller number of SFU, and
if it is small-scale it is necessary to increase it by actuating
larger number of SFU. For this reason such link is
Если Вам нужна помощь с академической работой (курсовая, контрольная, диплом, реферат и т.д.),
обратитесь к нашим специалистам. Более 90000 специалистов готовы Вам помочь.
Бесплатные корректировки и доработки. Бесплатная оценка стоимости работы.
Поможем написать работу на аналогичную тему
Получить выполненную работу или консультацию специалиста по вашему учебному
проекту
Нужна помощь в написании работы?
Мы - биржа профессиональных авторов (преподавателей и доцентов вузов). Пишем статьи РИНЦ, ВАК, Scopus.
Помогаем в публикации. Правки вносим бесплатно.